• img1
  • img2
  • img3

+8615763331999

sales@siberia-rubber.com

Home > News > Content
Experts Help You Analyze Why Hydraulic Hose Will Fail
Hebei Siberia Special Rubber Co.,Ltd | Updated: Sep 27, 2017

Hydraulic hose are often used in projects such as pumps, excavators and loaders, but it is still not being taken seriously; if there is a breakage, leakage, or loosening in the course of use Failure, they often do not analyze the reasons will be asked to replace the new, this has been repeated, this situation is not only for the user, for us is not a good phenomenon, to avoid.

We often see the hose is divided into rubber tube and plastic pipe, plastic pipe cheap, easy to install, but the carrying capacity is poor, easy to aging, only applies to the return pipe or drain pipe; rubber tube high pressure hose and low pressure hose two , High pressure hose generally by the outer layer, steel wire reinforced layer, the middle layer and the inner layer of four components. The inner layer is directly in contact with the hydraulic oil and is generally made of synthetic rubber. Hose failure generally manifested in the following four aspects: the outer layer of the fault, the inner layer of the fault, to strengthen the fault layer, the breakdown of the fault. Hydraulic hose failure causes and countermeasures are as follows:

1 outer layer of the fault

(1) the appearance of the hose crack

The main reason for the appearance of cracks in the hose is that the hose is bent in a cold environment. If you find the appearance of the hose crack, pay attention to observe the hose rubber is crack, decide whether to replace the hose immediately.

(2) the outer surface of the hose appears bubbling

The reason for the bulging of the outer surface of the hose is that the hose quality is unqualified or improperly used at work. If the bubble appears in the middle of the hose, mostly for the hose production quality problems, should be replaced by qualified hose; if the bubble appears in the hose connector, it is likely to be improper connection caused by the connector. Hose connector number is often removable, with two types of buckle. The detachable pipe joint is made of hexagon in the outer sleeve and joint core, which is easy to disassemble the hose. The buckle pipe joint is made up of the joint jacket and the joint core, and the outer layer is stripped at the time of assembly. , So that the hose to get a certain amount of compression.

(3) the hose is not broken but a lot of oil leakage

Hose a lot of oil leakage but did not find the rupture, the reason is the hose through the high pressure liquid flow, the rubber was eroded, abrasions, until a large area of leakage of wire layer led to a large number of oil leakage. This failure generally occurs at the bend of the pipe, check the replacement hose and ensure that the bending radius of the hose is in line with the technical requirements.

(4) hydraulic hose outside the layer of severe deterioration, the surface appears micro-crack This is the natural aging of the hose performance. As the aging of the deterioration, the outer layer of continuous oxidation of its surface covered with a layer of ozone, with the extension of time and thicker, the hose in use as long as the slight bending, it will produce small cracks. In case of this, replace the hose.


Contact Us
Hebei Siberia Special Rubber Co.,Ltd

Address: Add: No. 313, Jingxin Street, Jing county, Hebei province, 053500, China

Tel: +8615763331999

Fax: +863184338795

E-mail: sales@siberia-rubber.com

foottop